Our 10x10 PVA Module is adapted to be connected with other 4 modules, being able to carry out the composition combinations according to the needs of each species. It can be combined with other modular models with a different humidity system or with more foraging areas. With a new design of galleries, with 3D sliding covers, optimizing the available space and adjusting it to the number of ants that we have at all times.
Measurements: 10x10x1.5 cms
Our 10x10 PVA Module is adapted to be connected with other 4 modules, being able to carry out the composition combinations according to the needs of each species. It can be combined with other modular models with a different humidity system or with more foraging areas. With a new design of galleries, with 3D sliding covers, optimizing the available space and adjusting it to the number of ants that we have at all times.
To moisten the anthill, we will use a syringe without a needle and we will wet the Pva Foam until it does not absorb more water and letting the water spread over the acrylic plates of the anthill, but being careful not to flood the galleries excessively to prevent the ants drown. PVA Foam must always be damp.
It includes a flexible 3D test tube connector by default, to move the ants easily and safely, it also includes all the 3D White closing caps, to prevent the passage of light inside the anthill and also a 3D spout piece to connect with another non-modular model through flexible tube and a translucent flexible 3d connector to connect it to another modular safely.
